Sacroiliac joint dysfunction accounts for 25% of all cases of back pain in the lumbar spine area. With the Stablio Sacroiliac Brace, stabilizes and relieves pressure on this area, while a two-part sacroiliac pad stimulates the circulation and encourages the healing process. This also relieves cramps and helping to release tension.
Treat Sciatica, Including Pelvic, Back and Leg Pain Nerve Pain, Stabilize Sacroiliac Joint | Trochanter Brace | Anti-Slip and Pilling-Resistant
Sacroiliac Compression Brace | SI Joint Pain Relief Belt with Hip Support Pads for Bruised / Broken Tailbone Pain and Coccyx Injuries
– Brace for the stabilization of sacroiliac joints
– Special combination of elastic and non-elastic knit fabric
– Two-part sacroiliac silicone pad to stimulate the circulation and encourage the healing process
– Circular tension adjustable with additional tension straps
-Very Comfortable to wear thanks to narrow closure section (for example when sitting)
– Circular stabilization and relief of pelvis and symphysis
– Very comfortable to wear thanks to narrow closure section (for example when sitting)
This medical device is a function-securing brace for stabilizing the pelvis and
the sacroiliac joint.
Sacroiliac joint arthrosis, sacroiliac joint instability, sacroiliac joint blockage,
myalgias and tendopathies in the pelvic region, structural abnormalities after
lumbar spinal spondyloses.
Open the brace and loosen the tension straps. If required, you can use the
Velcro fastener to adapt the position of the silicone pads to the patient’s
individual circumstances. Then place the opened brace circumferentially
around the hip. Regarding the correct height, position the aid centrally on the
pelvis so that the upper edge (sewn-in label) of the brace is not higher than
the upper iliac crest or extends to the waist.
Push your fingers into the finger flaps intended for this purpose at the ventral
plate fastening. Then use both hands to pull the latch plates forwards evenly.
Place the left latching half on the stomach and position the right latching half
far enough over the left one so that you can Velcro it onto the left latching
half. When attaching it using Velcro, remove the fingers first from the left and
then the right finger flap.
Then take both tension straps in both hands and pull them forwards
simultaneously and evenly until the desired physical influence (stabilization) has been built-up.
Following this, attach both tension straps firmly to the
ventral plate using Velcro.
To remove the brace, open the tension straps and the front fastening and take
the brace off.
Polyamide (PA), cotton (BW), elastodiene/latex (LA)
The sewn in textile label provides the precise material composition.
SIZES Circumference of iliac crest
Size 1: 27.6″ – 33.5″ inches
Size 2 33.5″– 39.4″ inches
Size 3 39.4″ – 45.3″ inches
Size 4 45.3″ – 51.2″ inches
Size 5 51.2″– 57.1″ inches